Tech Corner

Thinking About Using a Machine for CAMduct?

Philip Charlson on Aug 26, 2015 3:13:00 PM

2 comments

Before setting up a new machine within the Installed Machines database, the following considerations must be reviewed and understood. Certain procedures must be in place, and certain information must be available, in order for a new post processor to output and write NC in the correct format.

Read More...

Adding Sloped Drainage Lines to CADmep with Design Line

Philip Charlson on Jul 16, 2015 3:14:00 PM

0 comments

Creating domestic piping type lines within CADmep is a simple task for most fabrication software users. The place where people tend to have some difficult times is when that pipe needs to be sloped for waste or vent type piping needs to be created.

Read More...

0 comments

Leave a comment